70 Low Voltage Products & Systems
AC 1006.9 - 5/03 ABB Inc. • 888-385-1221 • www.abb-control.com
Tuning parameters
Six parameters can be tuned individually if a more specific
adjustment is required. Each parameter is described in
Chapter 10 “ Functions” .
• Start ramp
• Stop ramp
• Initial voltage
• End voltage
• Step down voltage
• Current limit level
When all tuning parameters have been cycled through, the
following information will be displayed, Figure 21. Select
Yes
if all necessary parameters are tuned. If a new tuning is
required, select
Back
and follow the step
Tune Set
above
Chapter 7 - Settings and configuration
Figure 21: All tuning parameters have
been passed
Ready?
Yes Back
To Next Page
Loading...
