ABB Relion 615 series - Section 5 Connecting; Required Tools; Connecting Wires

Section 5 Connecting
5.1 Required tools
Only use a screwdriver and insert bits for Phillips (PH 1) cross-recessed head
screws (M3.5) when handling CT/VT terminals (X120) of screw-compression type.
A
B
A071178 V2 EN
Figure 38: Screwdriver for CT/VT terminals of screw-compression type
A MAX ∅5.5 mm
B MAX ∅5 mm
A
A071180 V2 EN
Figure 39: Insert bits for CT/VT terminals of screw-compression type
A
MIN 15 mm
5.2 Connecting wires
All connections are made on the rear of the case. No soldering is needed.
• Open the screw-compression type terminals before inserting any wires. By
default the terminals are closed at the time of delivery.
• Use fine wire in door mounting.
1MRS756375 K Section 5
Connecting
615 series 51
Installation Manual