14.8.2 Functionality
SEMOD176462-4 v8
The Single point generic control 8 signals SPC8GAPC function block is a collection of 8 single point
commands, designed to bring in commands from REMOTE (SCADA) to those parts of the logic
configuration that do not need extensive command receiving functionality (for example, SCSWI). In
this way, simple commands can be sent directly to the IED outputs, without confirmation.
Confirmation (status) of the result of the commands is supposed to be achieved by other means,
such as binary inputs and SPGAPC function blocks. The commands can be pulsed or steady with a
settable pulse time.
14.8.3 Function block
SEMOD176479-4 v5
SPC8GAPC
BLOCK
PSTO
^OUT1
^OUT2
^OUT3
^OUT4
^OUT5
^OUT6
^OUT7
^OUT8
ANSI07000143-3-en.vsd
ANSI07000143 V1 EN-US
Figure 478: SPC8GAPC function block
14.8.4 Signals
PID-3575-INPUTSIGNALS v5
Table 555: SPC8GAPC Input signals
Name Type Default Description
BLOCK BOOLEAN 0 Blocks the function operation
PSTO INTEGER 1 Operator place selection
PID-3575-OUTPUTSIGNALS v5
Table 556: SPC8GAPC Output signals
Name Type Description
OUT1 BOOLEAN Command output 1
OUT2 BOOLEAN Command output 2
OUT3 BOOLEAN Command output 3
OUT4 BOOLEAN Command output 4
OUT5 BOOLEAN Command output 5
OUT6 BOOLEAN Command output 6
OUT7 BOOLEAN Command output 7
OUT8 BOOLEAN Command output 8
1MRK 502 066-UUS B Section 14
Control
915
Technical manual
To Next Page
Loading...
