ABB RELION REX640 - Connecting local HMI to a relay through station network

7.4.3.2 Connecting local HMI to a relay through station network
PCM600 or WHMI can be used to read the network settings of the relay's station
port via Configuration> Communication> Ethernet> Network1 address.
1. On the LHMI, tap Network Settings to configure the network settings of the
main unit port X1.1.
Network settings are also available as an Advanced page.
Figure 105: Opening the Network Settings page
Commissioning
1MRS759118 D
128 REX640
Operation Manual