ABB REQ650 - Default Chapter; Table of Contents

Table of contents
Section 1 Introduction............................................................................7
This manual.............................................................................................. 7
Intended audience.................................................................................... 7
Product documentation.............................................................................8
Product documentation set..................................................................8
Document revision history................................................................... 9
Related documents..............................................................................9
Symbols and conventions.......................................................................10
Symbols.............................................................................................10
Document conventions...................................................................... 11
Section 2 Available functions.............................................................. 13
Back-up protection functions.................................................................. 13
Control and monitoring functions............................................................ 14
Station communication........................................................................... 18
Basic IED functions.................................................................................19
Section 3 Starting up........................................................................... 21
Factory and site acceptance testing....................................................... 21
Commissioning checklist........................................................................ 21
Checking the power supply.....................................................................22
Energizing the IED..................................................................................22
Checking the IED operation...............................................................22
IED start-up sequence.......................................................................22
Setting up communication between PCM600 and the IED.....................23
Writing an application configuration to the IED.......................................29
Checking CT circuits...............................................................................30
Checking VT circuits............................................................................... 31
Using the RTXP test switch.................................................................... 31
Checking binary input and output circuits............................................... 32
Binary input circuits............................................................................32
Binary output circuits......................................................................... 32
Checking optical connections................................................................. 32
Section 4 Establishing connection and verifying the IEC 61850
station communication.........................................................35
Setting the station communication..........................................................35
Table of contents
1
Commissioning manual