ABB SACE Tmax XT2 - Page 155

1SDH002031A1002 ECN000092998 Rev. B SACE Tmax XT2 – XT4 | 155
Remote
information
From the service connector (via Ekip Connect) or with communication by system bus, it is
possible to access additional information:
Information
Description
HW and Boot version
general module information
Flash CRC status and result
information on the correctness of the SW in the module
Ekip Link status
Signals connection errors of the Ethernet cable
SNTP Server Error
Communication error with the SNTP server
SNTP Server Synchronisation
Synchronism status with SNTP server
IEEE 1558 status
Valid with IEEE 1588 Master = ON, communicates the
presence (Slave or PTP Master Active) or absence (PTP
Master but Passive) of a higher level master
GOOSE Missing
Signals whether an expected GOOSE has been received
Configure Mismatch
A received GOOSE does not comply with the expected
structure
Decode Error
Sequence number error
Remote programmable
statuses (from E to R)
Condition (true/false) of the programmable statuses and
information on selectivity arising from logics defined in the
configuration files loaded on module IEC 61850
Remote inputs of zone
selectivity