Operating Instructions SYN 5201/SYN 5202
Document No Art Part Language Revision page
abb
ABB Switzerland Ltd
3BHS109762 E01
en D 79
Template: CHIND Techn doc stand, A4 P de, R1.DOT; Filename: 3BHS109762E01 D.doc; Print: 12/6/2011 5:48:00 PM; Save: 12/1/2011 2:37:00 PM; CHIND No. 3BHS109763 ZAB D14 Rev. -; I-Q
7 Operating instructions
7.1 Operation for commissioning and maintenance purposes
7.1.1 Commands
The following commands can be carried out using the keypad.
Function Commands Keys
LCD Switch on LCD Press any key
Change line (actual value block only)
Addresses Address change in menu (vertical)
Fast address change in menu,
from group to group (vertical)
Address change from parameter
set to parameter set (horizontal)
Parameter
values
Change parameter values: slow
fast
& or &
& or &
Load single parameter value into
random access memory RAM
&
Reset actual parameter value to
default
&
Change polarity of
UOffset and
Offset parameters; enable
blocking of the configurable inputs
&
Changes of Stop synchronizing process
&
status Block device
(Device is in setting mode, i.e.
parameter setting is released)
Hold down in combination with
another key for at least 2 s
Cancel fault
&
Set device to “Ready“(all settings
will be loaded from the RAM into the
read-only memory (ROM)
&
Test
Enable test functions
& &
functions
Start test functions
&
Cancelling test functions &
&
&
c
c
c
c
c
c
c
DATA
c
DATA
DATA
c
c
DATA
c
c
DATA
c
c
c
c
DATA
c
c
c
ccc
c
c
c
c
c
c
c
c
c
c
DATA
DATA
DATA
DATA
c
To Next Page
Loading...
Need help?
General
