ABB TPL76-C33

Operation Manual / TPL76-C
1 Preliminary remarks / 1.9 Contact information
© Copyright 2018 . All rights reserved. HZTL2485_EN Revision F April 2018
1.8.1 Explanation of the rating plate
The recommended replacement intervals and the corresponding opera-
tional limits are jointly defined with the engine manufacturer. This in-
formation is specific to the system.
Operation above the indicated values n
Bmax
, t
Bmax
can considerably shorten
the recommended replacement intervals. In such cases, we recommend that
you contact the nearest official ABB Turbocharging service station.
n
Mmax
and t
Mmax
normally apply only when running at overload (110%) during
trials on the engine test bed. These limits can also be permitted during op-
eration for special applications. Operation above n
Mmax
and t
Mmax
is not per-
mitted.
Non-observance of the recommended replacement intervals can increase
the risk of unpredictable component failures.
1.8.2 Positions of the rating plates
A rating plate is attached to the turbocharger foot, one on the left and
one on the right. On turbochargers with insulation from ABB, at least one
additional rating plate is attached to the insulation of the gas outlet cas-
ing.
1.9 Contact information
Contact information for the official service stations of ABB Turbo Sys-
tems is available online.
u Scan the QR code to access our website.
ABB Turbo Systems Ltd
Bruggerstrasse 71a
CH-5401 Baden
Switzerland
www.abb.com/turbocharging
Page 14 / 133