ABB UniGear ZS1 - Page 59

57
Fix the rear connection plate between the two gas duct panels (figures 93).
Figure 92: Rear connection plates.
Nr. 8 screws 8x30
Nr. 8 M8 washer
Repeat the above described operations for all the panels.
The next operation is the fixing of the left and right end side (figures 93).
Figure 93: Side plates.
Nr. 13 screws 8x30
Nr. 13 M8 washer
The last operation in order to complete the gas duct is the fixing of the gas duct extension on both sides
(figure 94).
Figure 94: Side plates.
Nr. 10 screws 8x30
Nr. 10 M8 nuts
Nr. 10 M8 washer