ABL WALLBOX eMH1 - Preparing and fixing the wallbox in place

Installation – Preparing and fixing the wallbox in place |
11
Preparing and fixing the wallbox in place
Continue to prepare the wallbox:
8 Open the housing cover of the wallbox using the
key supplied and flip it up.
9 Loosen the four screws of the upper part of the
housing using the screwdriver.
y Keep the four screws in a safe place.
10 Remove the upper part of the housing from the
housing base.
11 Remove the rubber grommet at the bottom of the
housing base: use the utility knife to cut an open-
ing for the power supply cable into the rubber
grommet and then replace it in the housing base.
y If the power supply cable is surface mounted,
you must break off the plastic tongue in the
lower section of the housing base using the
pliers.
12 Using the electric drill and suitable bit, loosen
the internal strain relief, which is located on
the inside of the housing base above the rubber
grommet.
13 Insert the supply cable through the rubber grom-
met into the housing base.
14 Hang the housing base onto the countersunk
screw you inserted at the mounting point in
Step7.