Abus CFA 1000 - Page 54

54
Beforetheadjustmentsonthedoorlockactuatorarecontinued,thishastobemountedabove
thefasteningelementonthecylinderlock.
• Insertthekeyintothecylinderlock,unlockthe
lockandputthekeyintotheneutralposition
(inwhichthekeycouldbewithdrawn).
• Guidethedoorlockactuatoroverthekey.Posi
-
tionitcompletelyonthefasteningelement.
• Thedoorlockactuatorshouldbemountedon
the fastening element with the two hexagon
screwsextendedatrst(M3*14mm).
 Screw in the screws fully with the enclosed
hexagonwrenchwithoutapplyinganyforce.
• Openthedoor.Thisisnecessarysothatthe
door lock actuator can detect the end stops
ofthelockinthefollowinginitialisationdrive
withoutanyhindrance.
Do not tighten screw too strong, otherwise driver could get stuck and possibly
causemalfunctions(e.g.openingdoorfromoutsidebykeycouldbecomedif-
cult).