Abus CFA 1000 - A) Setting Acknowledgement Tone; B) Procedure When Replacing The Lock; C) Information For Dealing With The Change Code System; Miscellaneous

68
14. Miscellaneous
a) Setting acknowledgement tone
Theacknowledgetoneofthedoorlockactuatorcanbesetinseveralvariations.4differentpitches
areavailableandtheoption”soundoff”.
Proceed as follows:
• Pressthesmall”setup”keybrieyafterwhichthenextacknowledgementtoneisselectedand
printedascontrol.Withtheoption”Soundoff”,ashorttonesoundsasanadjustmentacknowl-
edgement.
• Bypressingthekey(setup)onceagainbriey,thenextacknowledgementisselectedetc.
b) Procedure when replacing the lock
Whenchangingthedoorlockactuatortoanothercylinderoranotherdoor/doorlock,thishasto
beadaptedagaintothecylinderlock/lock/door.
+
 Forthis,thebasicsettingshavetobereset.
• Pressthesmallkey”Setup”forapprox.2secondstoactivatethesettingmode.
• Atthebeginningthesymbol”locked”( )willappearaswellasthedisplay”1”fortherstsetup
stepandtherotatingdirectionsymbol.
• Continuethesettingsasdescribedinsection”10.Basicsettings”.
c) Information for handling the change code system
Ifthekeysoftheradioremotecontrolareoperatedtoooftenwhilethesearelocatedoutsidethe
receptionrange,re-synchronisationisnecessary.
Ifthedoorlockactuatordoesnotreactontherstkeycontact,thiswilltakeplacebypressing
thesamekeyagain.
 Pleasenotethat,duetothesafetyfeaturesofthechangecodeprocess,althoughitis
possibletotrainaradioremotecontroltoseveraldoorlockactuator, malfunctioncan
occurduringoperationduetosynchronisationproblems(seeabove).
 Thismeansthatsynchronisationproblemsarepossiblewithremotereceivers.With
severalreceiverswithinthereceptionrange,uncontrolledlockingandunlockingproc-
essesareconceivable.