Accu-Chek ACTIVE User Manual

8
Steps before testing
2
Checking the display
You can check if all of the display elements are properly displayed, by carrying out a full display check.
1
Compare the elements displayed on your meter with the display
shown here.
If any of the display elements are missing or the unit of measurement
shown for the blood glucose results is not the correct one, please ask
your dealer/pharmacy to exchange the meter.
Press the M and S buttons at the same time to end the display check
and turn the meter o.
With the meter turned o, press
the M and S buttons at the same
time for approximately 2 seconds
until the meter is switched on.
mg/dL meter mmol/L meter
2

Accu-Chek ACTIVE Specifications

General

Measurement Range	10-600 mg/dL
Sample Size	1 - 2 μL
Test Time	5 seconds
Memory Capacity	500 results
Display Type	LCD
Automatic Coding	Yes
Blood Sample	Capillary whole blood
Dimensions	97.8 x 46.8 x 19.1 mm
Battery Type	1 x 3V lithium battery (type CR2032)
Battery Life	Approximately 1000 tests
Data Transfer	Via infrared (IR) to computer
Operating Conditions	8-42°C, 10-85% RH