108
Using the meter as a notebook
Farbe: P 021 – Prüfmittelnummer: 201
When the beep tone or Acoustic Mode is turned on (0n1 or 0n2),
the meter beeps five times at approx. 1 second intervals while
the result is being erased (the last beep is longer than the pre-
ceding four).
When you later retrieve results from memory, the erased result
appears as three horizontal bars ---.
As long as the fifth beep has not sounded, you can stop the result
from being erased by releasing the < and > buttons again.
The flashing result continues to be displayed. You can re-start the
erasing operation by pressing and holding down the < and >
buttons again at the same time.
As long as the result has not been erased, i.e. (lr is displayed
or the result is flashing, you can quit the erasing procedure. To do
so, press the Þ button. The meter turns off.
If the last result has already been erased, three horizontal bars
--- flash following (lr. Press the Þ button to turn the meter
off.
To Next Page
Need help?
General
