Machine Maintenance Procedures 3-15
HDD (Hard Disk Drive) Module Removal 0
Prerequisite:
Base Door Removal
1. Find HDD module (A) on the base assembly as shown in Figure 3-6.
2. Remove two (2) screws (B) securing the HDD module in place (Figure 3-11).
3. Pull the tab (C) to release HDD module from mainboard connector (D). Refer to
Figure 3-11.
Figure 3-11. HDD Module
4. Remove two (2) screws (E) from HDD bracket (F) (Figure 3-12).
Figure 3-12. HDD Module
To Next Page
Loading...
