Machine Maintenance Procedures 3-25
Touchpad Board Removal 0
Prerequisite:
Upper Case Removal
1. Locate touchpad board (A) on upper case. (Figure 3-23)
Figure 3-23. Touchpad Board
2. Disconnect touchpad board FFC (B) from touchpad board connector (C).
3. Remove screws (D) from upper case.
4. Remove touchpad board from guidepins (E) on upper case.
Touchpad Board Installation 0
1. Align and install touchpad board (A) with guidepin (E) on upper case. (Figure 3-23)
2. Install and secure screws (D) to upper case.
3. Install touchpad board FFC (B) to touchpad board connector (C).
4. Install upper case.
ID Size Quantity Screw Type
D M2.0x3.0 t=0.4 2
To Next Page
Loading...
