Machine Maintenance Procedures 3-31
RTC Battery Removal 0
Prerequisite:
Mainboard Removal
1. Remove mylar (A) to reveal RTC battery. (Figure 3-29)
Figure 3-29. RTC Battery Mylar
2. Lift battery (C) from opening (B) on mainboard connector (D). (Figure 3-30)
Figure 3-30. RTC Battery
3. Remove battery from mainboard connector.
Follow local regulations for battery disposal.
RTC Battery Installation 0
1. Install RTC battery (C) into mainboard connector (D). (Figure 3-29)
2. Press to secure.
3. Secure mylar (A) to cover RTC battery.
4. Install mainboard.
To Next Page
Loading...
