Machine Maintenance Procedures 3-27
Bluetooth Module Removal 0
Prerequisite:
Upper Case Removal
1. Locate bluetooth module (A). (Figure 3-25)
Figure 3-25. Bluetooth Module
Bluetooth cable is connected to module and mainboard. Use caution when lifting
or removing bluetooth module.
2. Remove bluetooth module from adhesive on lower case.
3. Disconnect bluetooth cable (B) from bluetooth connector (C). (Figure 3-26)
Figure 3-26. Bluetooth Cable
Bluetooth Module Installation 0
1. Connect bluetooth cable (B) to bluetooth connector (C). (Figure 3-26)
2. Align and secure bluetooth module (A) to adhesive on lower case. (Figure 3-25)
3. Install upper case.
To Next Page
Loading...
