3-38 Machine Maintenance Procedures
3. Starting from bottom edge of bezel, pry bezel up and away from LCD cover. (Figure 3-37)
Figure 3-37. Lifting LCD Bezel
4. Move along edges until bezel is separated from LCD cover.
5. Remove bezel.
LCD Bezel Installation 0
1. Align hinge side of bezel to LCD cover and press down until there is no gap between bezel
and LCD module.
Make sure cables do not get caught underneath bezel, it may cause damage to
cables.
2. Move along edges until bezel is secure to LCD cover.
3. Install and secure screws (B) to LCD cover. (Figure 3-36)
4. Install mylar screw covers (A). (Figure 3-35)
5. Install LCD Module.
ID Size Quantity Screw Type
B M2.0x4.0 Ni 2
To Next Page
Loading...
