Table of Contents
Chapter 1 Introduction 1-1
Highlight 1-1
Computer Compatible 1-4
Chapter 2 Disassembly Procedure 2-1
Equipment Needed 2-1
Remove Lamp Module 2-2
Remove Top Cover ,Keypad BD and Rear Cover 2-3
Remove Front Cover,Receiver 2-6
Remove Each Side Cover 2-7
Remove Main Board 2-8
Remove Side Shielding Module 2-9
Remove Fan Module 2-10
Disassemble Lamp Driver Module 2-11
Disassemble LVPS Module 2-12
Disassemble Color Wheel Module 2-13
Remove Engine Module and Fan Module 2-14
Remove Thermal Switch 2-15
Remove Heatsink and 2 Springs 2-16
Disassemble DMD Chip 2-17
Disassemble Focus Ring 2-18
Disassemble Front Light Cut and Right Light Cut 2-19
Remove EMI Shielding Module and Bottom Cover 2-20
Remove Thermal Sensor Board 2-21
Remove Elevator Module 2-22
Remove Lens Support and Interrupter Switch 2-23
Chapter 3 Troubleshooting 3-1
Equipment Needed 3-1
Main procedure 3-1
II
Condential PH530