ENGLISH
PSPIX² • User manual
34
NOTE:
The “Erasing” mode takes longer than reading an IP. This ensures that the IPs are correctly erased, even
when they have been stored in darkness for an extended period.
NOTE:
To return to the home page, click on the “Home” icon . If you do not, this will happen
automatically after a few seconds.
7.5 ECO MODE AND STANDBY MODE
Eco mode
Following several minutes of inactivity, the backlight on the PSPIX Touch screen will dim to save energy. The
“Eco mode” is confi gurable from the PSPIX Touch screen in the “Setup”/”Confi guration”/”Time” menu. By
default, it is set at 5 minutes. You can set it for time periods between 0 minutes and 60 minutes
NOTE:
All of the animations and buttons displayed on the Touch screen remain visible when it is in “Eco mode”.
The PSPIX system automatically leaves “Eco mode” when the user changes the status of the PSPIX system.
This includes when he/she places an IP in the insertion slot, touches the screen or reserves the PSPIX system
from the acquisition module from his/her workstation.
Standby
A few minutes after closing the PSPIX acquisition module, the Touch screen of the PSPIX system will
completely switch off to reduce its power consumption. This standby time is confi gurable from the PSPIX
acquisition module from the “Setup” menu in the “Confi guration” tab. By default it is set at 15 minutes. You
can set it for time periods between 0 minutes and 60 minutes
The PSPIX system automatically exits standby mode when the user restarts his/her imaging software, opens
a patient fi le and launches the PSPIX acquisition module.
You can also touch the Touch screen to bring it out of its standby mode.
To Next Page
Loading...
