Acteon PSPIX - Multi-User Configuration; Reservation from the Screen

ENGLISH
PSPIX² • User manual
30
Multi-User Confi guration
NOTE:
The PSPIX system may be connected and used by one computer (single-user confi guration) or by several
computers (multi-user confi guration). The multi-user confi guration allows you to share the PSPIX with
a maximum of ten computers. Each workstation uses the PSPIX system successively. The PSPIX system
therefore has the same function: send an image to a given computer via the acquisition module.
NOTE:
It is possible to reserve the PSPIX system:
-via the PSPIX touch screen
-OR via the PSPIX acquisition module from the workstation.
• Reservation from the PSPIX screen:
1. To reserve the PSPIX system from the touch screen , directly click on the number that corresponds to your
workstation. This is located on the multi user home page.
NOTE:
Workstations in blue represent computers that are connected and in operation. Workstations in white
represent disconnected computers. Workstations in grey represent unassigned workstation numbers.
NOTE:
In order for the station number to appear in blue on the Touch screen the dental imaging software must
be open on the patient fi le and the acquisition module must be switched on.
NOTE:
Once the PSPIX system is reserved, the workstation number, the patient and practitioner names are
displayed on the PSPIX system’s touch screen .
A countdown on the screen shows the time remaining to insert the IP in the PSPIX system. At the end of
this time, the PSPIX system will automatically free itself up and return to the multi-user home page.
NOTE:
When the PSPIX system is reserved for a given workstation number, a notifi cation will appear in the
acquisition module of the other users. It is impossible for them to reserve the PSPIX system during this
period.
2. Then follow steps 2 to 7 for the single user confi guration described above for reading the IP.
https://stomshop.pro