EasyManuals Logo

Adafruit Audio FX User Manual

Adafruit Audio FX
45 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
Troubleshooting
Here's some hints to help you with your sound board:
Doesn't show up as a drive on my computer
Check you have a data-capable USB cable, or try another cable just in case
On some computers, give it a minute, the first time it sees the drive it may try to read data from it and its a bit slow (we
saw this on Windows 7 in particular)
Make sure the green LED near the microUSB port is lit, that tells you it has power, however the red LED should not be
lit
I can't get audio to play when I trigger the pins
Is the board connected to a computer USB port? You cannot use it as a USB storage device and play audio at the
same time, even if you 'eject' the drive, you can only power it from battery or a power-only USB port like a USB wall
adapter.
Do you see the red LED blink or turn on at all when you trigger the pin? You should see something blink/flicker when it
plays audio.
Make sure nothing is connected to the CS or UG pins!
In case there's something amiss with your audio files, try using our audio file downloads, remember they go in the base
directory of the USB drive, they cannot go in a folder or in a compressed zip!
To trigger, connect a wire from a GND pin to a numbered pin
With headphones in the headphone jack (or speakers connected), plug the board into USB. You should hear a
beep/tone when it detects that it is connected to a computer
© Adafruit Industries https://learn.adafruit.com/adafruit-audio-fx-sound-board Page 41 of 45

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Adafruit Audio FX and is the answer not in the manual?

Adafruit Audio FX Specifications

General IconGeneral
BrandAdafruit
ModelAudio FX
CategoryRecording Equipment
LanguageEnglish