Page 16
Rev. : 002
HF - VISION 10 & PHOENIX
Lighting Technologies
6.2.1.5.2. Adjustments - Display Contrast
Key sequence:
Display :
10:15
MENU MENU=EXIT
ADJUSTMENTS
CONTRAST: 7
UP & DN TO SEL.
This sub-menu is used to change the display's contrast in order to optimise the reading
according to the viewing angle and lighting level.
The display contrast can be altered between 0 and 10 by the use of the keys 'up' ↑
and 'down' ↓.
The default factory setting is 7.
6.2.1.5.3. Adjustments - Auto Sleep Timer
Key sequence:
Display :
10:15
MENU MENU=EXIT
ADJUSTMENTS
AUTO SLEEP: 2
UP & DN TO SEL.
This sub-menu is used to enable and disable an auto sleep timer and assign operating
times in minutes.
The auto sleep mode can be altered between 0 and 5 (minutes) by the use of the keys
'up' ↑ and 'down' ↓. If '0' is selected, auto sleep modus is off, in this case the remote
control unit would remain on until the internal battery is too low and has to be recharged.
In case any value from 1-5 is assigned, the device switches off in stand-by mode
automatically after the corresponding time in minutes (1 minute -> 5 minutes) if no key
is activated. The device can then be activated again by pushing key MENU.
MENU
→→
→→
→
→→
→→
→
42
→→
→→
→
→→
→→
→
MENU
43
To Next Page
Loading...
Need help?
General
