8230 Optical Power Meter Operation Manual
ALPHABETICAL INDEX
I-1
[Numerics]
8230 Specifications ................................. 8-1
[A]
AC Adaptor ............................................. 1-9
Accessories ............................................. 1-2
ANALOG OUT ...................................... 5-4
[B]
Backing up and Initializing the Setting
Parameter ................................................ 3-4
Backing up the Setting Parameter ........... 3-4
Battery ..................................................... 1-9
Before Asking for Repair ........................ A-1
Bottom Side ............................................ 2-7
[C]
CALIBRATION ..................................... 7-1
Calibration .............................................. 1-13
Calibration Operation ............................. 7-5
Calibration Point and Judgment Criteria 6-6
Calibration Procedure ............................. 7-8
Calibration Wavelength Selection
Function .................................................. 5-5
Causes of the Generated Calibration
Errors ...................................................... A-3
Checking Operations ............................... 1-11
Cleaning .................................................. 1-12
Cleaning the 8230 ................................... 1-12
Cleaning the Incident Surface of
the Sensor ................................................ 1-12
Connectable Sensors ............................... 1-3
Connecting the Sensor ............................ 3-3
Connecting to a Personal Computer ....... 4-2
CONTROLLING THE 8230 BY REMOTE 4-1
Current Measurement Calibration .......... 7-8
Current Measurement Calibration Point and
its Allowable Range ................................ 7-4
[D]
Display Description ................................ 2-5
Disposal and Recycle .............................. 1-14
Driver for Control ................................... 4-1
[E]
Error Messages ....................................... A-2
[F]
Front Side ................................................ 2-1
Function Description ............................... 2-1
[G]
General Specifications ............................ 8-3
[H]
How to Connect Instruments .................. 6-2
How to Connect the Instrument .............. 6-6, 7-3
How to Initialize ..................................... 3-5
HOW TO PERFORM MEASUREMENTS 3-1
How to Set the Remote Command ......... 4-13
How to Store and Transport the Instrument 1-12
How to Test the Performance ................. 6-2
[ I ]
Instrument Specifications ....................... 8-1
INTRODUCTION .................................. 1-1
IV Offset Calibration .............................. 7-8
[M]
Measurement Data Output Format ......... 4-4
Measurement Procedure ......................... 3-3
Measuring Instrument, Cable, and Other
Instruments Required for Calibration ..... 7-1
Menu Description ................................... 3-2
[O]
Operating Environment ........................... 1-9
Optical Power Calibration and Wavelength
Sensitivity Correction ............................. 5-3
Optical Sensor Specifications ................. 8-4
Option ..................................................... 8-3
Option to Use Old-Type Sensors
(OPT8230+70) ........................................ 1-8
Options and Accessories ......................... 1-8
Outline .................................................... 4-1
[P]
PANEL AND FUNCTION DESCRIPTION 2-1
PERFORMANCE TEST ........................ 6-1
Performance Test for Optical Sensors .... 6-5
Performance Test for the 8230 ................ 6-1
Power Supply .......................................... 1-9
Precautions .............................................. 7-2
Precautions when Using This Instrument 1-11
Principle of Measurement ....................... 5-1
ALPHABETICAL INDEX ALPHABETICAL INDEX
To Next Page
Loading...
Need help?
General
