User’s Manual
AIMB-240 Series User’s Manual
59
3.5.2.4 CPU Feature
This item allows you to setup the CPU thermal management function.
Item Options Description
Thermal Management
Thermal Monitor 1
Thermal Monitor 2
TM2 Bus VID 0.700 ~ 1.708
Execute Disable Bit Enabled, Disabled
3.5.2.5 Hard Disk Boot Priority
This item allows you to select hard disk boot priority when First Boot Device item set Hard
Disk
3.5.2.6 Virus Warning
This function allows you to choose the VIRUS Warning feature for IDE Hard Disk boot
sector protection. If this function is enabled and someone attempt to write data into this
area, BIOS will show a warning message on screen and alarm beep.
Item Description
Enabled
Activates automatically when the system boots up causing a warning message to
appear when anything attempts to access the boot sector or hard disk partition table.
Disabled
No warning message will appear when anything attempts to access the boot sector or
hard disk partition table.
3.5.2.7 Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power up the computer. If it
is set to Enable, BIOS will shorten or skip some check items during POST.
Item Description
Enabled Enable quick POST
Disabled Normal POST
3.5.2.8 First/Second/Third/Other Boot Device
The BIOS attempts to load the operating system from the devices in the sequence selected
in these items.
Item Description
Floppy Floppy Device
LS120 LS120 Device
HDD-0~4 Hard Disk Device 0, 1, 2, 3, 4
SCSI SCSI Device
CDROM CDROM Device
ZIP100 ZIP-100 Device
USB-FDD USB Floppy Device
USB-ZIP USB ZIP Device
USB-CDROM
USB CDROM Device
USB-HDD
USB Hard Disk Device
LAN Network Device
Disabled Disabled any boot device
3.5.2.9 Book Up Floppy Seek
Seeks disk drives during boot up. Disabling seeds boot up.
Item Description
Enabled Enable Floppy Seek
Disabled Disable Floppy Seek
3.5.2.10 Boot Up NumLock Status
Select power on state for NumLock.
Item Description
To Next Page
Loading...
Need help?
General
