43 AIMB-780 User Manual
Chapter 3 BIOS Operation
3.3.2 IDE Configuration
Figure 3.6 IDE Configuration
SATA Configuration
This can be configured as IDE, RAID or AHCI.
SATA1/SATA2/SATA3/SATA4/SATA5/SATA6
While entering setup, the BIOS automatically detects the presence of SATA devices.
This displays the status of SATA device auto-detection.
Hard Disk Write Protect
Disable/Enable device write protection. This will be effective only if device is
accessed through BIOS.
IDE Detect Time Out (Sec)
This item allows you to select the time out value for detecting ATA/ATAPI device(s).
ATA(PI) 80 Pin Cable Detection
Select the mechanism for detecting 80Pin ATA(PI) Cable. There are three options,
[Host & Device]\[Host]\[Device]
To Next Page
Loading...
