Advantech ARK-2150 - Table 2.10: USB 3.0 Connector

17 ARK-2150 User Manual
Chapter 2 H/W Installation
2.3.1.6 USB2.0 Connector
ARK-2150 provides up to four USB2.0 interface connectors, which give complete
Plug & Play and hot swapping for up to 127 external devices. The USB interface
complies with USB UHCI, Rev. 2.0 compliant. The USB interface can be disabled in
the system BIOS setup. Please refer to Table. 2.7 for its pin assignments. The USB
connectors are used to connect any device that conforms to the USB interface. Most
digital devices conform to this standard. The USB interface supports Plug and Play.
Figure 2.10 USB2.0 connector
2.3.1.7 VGA Connector
The ARK-2150 provides a high resolution VGA interface connected by a D-sub 15-
pin connector to support a VGA CRT monitor. It supports display resolutions of up to
1900 x 1200.
Figure 2.11 VGA Connector
Table 2.10: USB 3.0 Connector
Pin Signal name Pin Signal name
1 +5V 2 USB_data-
3 USB_data+ 4 GND
5 SSRX- 6 SSRX+
7 GND 8 SSTX-
9SSTX+
Table 2.11: USB2.0 Connector
Pin Signal name Pin Signal name
1 +5V 2 USB_data-
3 USB_data+ 4 GND
Table 2.12: VGA Connector Pin Assignments
Pin Signal Name Pin Signal Name
1 Red 2 Green
3 Blue 4 NC
5GND 6 GND
7GND 8 GND
9NC 10GND
11 NC 12 NC