UNO-2484G_V2 User Manual 44
– Power Limit 1 Time Window
Power Limit 1 Time Window value in seconds. The value may vary from 0 to
128. 0 = default value (28 sec for Mobile and 8 sec for Desktop). Defines time
window which TDP value should be maintained.
– ConfigTDP Turbo Activation Ratio
Custom value for Turbo Activation Ratio. Needs to be configured with valid
values from LFM to Max Turbo. 0 means don’t use custom value.
Platform PL1 Enable
Enable/Disable Platform Power Limit 1 programming. If this option is enabled, it
activates the PL1 value to be used by the processor to limit the average power
of given time window.
Platform PL2 Enable
Enable/Disable Platform Power Limit 2 programming. If this option is disabled,
BIOS will program the default values for platform Power Limit 2.
Power Limit 4 Override
Enable/Disable Platform Power Limit 4 override. If this option is disabled, BIOS
will leave the default values for platform Power Limit 4.
C States
Enable/Disable CPU Power Management. Allows CPU to go to C states when
it’s not 100% utilized.
Power Limit 3 Settings
Power Limit 3 settings
Power Limit 3 Override
Enable/Disable Power Limit 3 Override. If this option is disabled, BIOS will leave
the hardware default values for Power Limit 3 and Power Limit 3 Time Window.
CPU Lock Configuration
CPU Lock Configuration.
– CFG Lock
– Overclocking Lock
Enable/Disable Overclocking Lock (BIT 20) in FLEX_RATIO (194) MSR.
GT – Power Management Control
To Next Page
Loading...
Need help?
General
