- 25 -
TSE-N 01.03 A.B. 599 50 75 69 EN
Service Program
Fault indication by display or cycle run display.
Fault code Type of fault Remedy Alarm
Code
Customer Register
E11
Water tap closed
Valve does not open / interruption
Valve flow rate to low
Air trap system leaking
Open tap
Change the valve
Clean filter
Replace air trap
0S
E21
Pump blocked / not working
Pump interrupted
Reduced pump output rate
Pressure sensor defect
Pressure switch defect
Remove foreign object
Replace pump
Check draining system
Replace pressure sensor
Replace pressure switch
0S
E31
Pressure sensor defect
Frequency of the pressure sensor out of limit
Cable interrupted
Replace pressure sensor
Replace cable
1A
E32
Calibration problems pressure sensor
After initial calibration the waterlevel not in between 0 -
66mm and antiboil level off
Open tap
Change the valve
Clean filter
Replace air trap
Replace pressure sensor
0S
E33
Incongruence between pressure sensor and antiboil
level 1
Fault has to be for a time longer than 60 sec.
Replace pressure sensor
Replace cable
Replace air trap
1A
E34
Incongruence between pressure sensor and antiboil
level 2
Fault has to be for a time longer than 60 sec.
Replace pressure sensor
Replace cable
Replace air trap
1A
E35
Safety level (Pressure sensor)
Level has to be 300mm for
For a time of more than 15 sec
Drain pump will be activated
Until level is below 120 mm
Replace pressure sensor
Replace cable
Replace air trap
1A
E36
Antiboil 1 sensing failure 1
Input voltage allways 0V
Change mainelectronic
1A
E37
Antiboil 2 sensing failure
Input voltage allways 0V or 5V
Change mainelectronic
1A
E38
Airtrap blocked
No pressure differences detected
Change airtrap
Clean airtrap
1A
E41
Door lock defective
Cable defective
Replace doorlock
Replace cable
0S
E42
Door lock defective
Door is unlocked during the cycle Tout 15 sec
Door is not unlocking at the end of cycle Tout 3 min
Replace doorlock
Replace cable
0S
E43
Door lock triac defective Replace cable
Change mainelectronic
0S
E44
Door lock sensing failure
Inputvoltage allways 0V or 5V
Change mainelectronic
1A
E45
Door lock triac sensing failure
Inputvoltage allways 0V or 5V
Change mainelectronic
1A
E51
Motortriac short circuit
Motor cable short circuit
Change mainelectronic
Replace cable
1A
E52
No signal from tachogenerator
Motor blocked
Motor cable defective
Replace tachognerator
Replace motor
Replace cable
1A
E53
Motor triac sensing failure
Input voltage allways 0V or 5V
Change mainelectronic
1A
E54
Motor relay defect Change mainelectronic
1A
E55
Motor circuit interrupted Change motor
Change cable
1A
E10
E20E30E40E50
To Next Page
Loading...
