AEG Electrolux EMW2000 - Further Fault Code Analysis; Extended Fault Code Directory; Alarm Code Composition

- 26 -
TSE-N 01.03 A.B. 599 50 75 69 EN
Service Program
Fault indication by display or cycle run display.
Fault code Type of fault Remedy Alarm
Code
Customer Register
E61
Insufficient heating
Maximum heating time expired
NTC defective
Heating element defective
Connection heating element interrupted
Replace NTC
Replace heating element
Replace cable
3
E62
Overheating:
- Temperature greater 88°C for a time longer than 5
min
- NTC defective
- Cable defective
Replace NTC
Replace heating element
Replace cable
2A
E66
Heating relay defective
Incongruence between
antiboil 2 and relay
Replace pressure switch
Replace cable
2A
E71
NTC short circuit
NTC interruption
Replace NTC
3S
E84
Recirculation pump sensoring failure.
Input voltage allways 0V or 5V
Replace mainelectronic
1A
E85
Recirculation pump defective
Triac defective
Replace recirculation pump
Replace mainelectronic
2A
E91
Interrupted communication
between In/Output electronic and mainelectronic
Replace cable
Replace mainelectronic
Replace In/Output electronic
E92
Incongruence between
In/Output electronic and mainelectronic
In/Output electronic is
incompatible with
mainelectronic
E93
Configuration error Wrong configuration of the
machine
1A
E94
Loss of cycle datas Replace mainelectronic
1A
EA1
DSP defective Replace DSP
Replace mainelectronic
Replace wiring
Main motor belt broken
EF1
Filter dirty
Drainhose closed
Time for draining to long
Cleaning drainhose and filter
Checking drainpump
EF2
Detergent overdosing
To much foam during the drain phase
Filter dirty
Drainhose closed
Cleaning drainhose and filter
Checking drainpump
Not overdosing
EF3
Aqua Control system activated
Drain pump cable defective
Drain pump interruption
Floating swirch defective
Leakage in the machine
Replace cable
Replace drain pump
Replace floating switch
2A
E60E70E80E90EA0EF0
Composition alarm codes
Alarm state
Reactivate
the machine
with
0
Program cycle interrupted.
S
Start Button
1
Program cycle interrupted.
Door locked
A
Off / On
2
Program cycle stopped.
Drain pump is activated.
3
Heating step is skipped
www.mosogepszerviz.info