Step 8
PreparingToSew
Note:
Bobbin winding
a: Pull out the Hand Wheel click.
b: Spool Pin is used for holding
the spool of thread in order to feed
the thread to the machine. To use,
pull the spool pin out and place the
spool of thread over it, To store,
remove the spool of thread and
push back.
When pull out the Hand Wheel ,
pull it as far as it goes. The “Click”
you heard is very important.
c: Place the spool of thread onto the
spool pin.
Pull the thread from the spool and
guide it around the Thread guide
and Bobbin winder Thread guide
d: Insert the thread through one of
the holes in the Bobbin from the
inside to the outside.
Wind the thread a few times by
hand around the empty bobbin in a
clockwise direction.
8
To Next Page
Loading...
