Step 5
Note:
- Ensure that the needle higher than
needle plate and fabric before
rotate the stitch selector. Otherwise
will bent the needle.
Sewing buttonholes
-Rotate the Hand Wheel
anticlockwise (toward you) to bring the
thread take up lever to highest position.
But incorrect the Hand Wheel
rotating direction will cause upper
and bobbin thread blockage upper
the needle plate.
Note: It is recommended that you
practice sewing buttonholes on a
scrap piece of fabric before trying
to sew them on the actual garment.
Preparing to sew a buttonhole:
Measure the diameter of the button
to be used and ass 1/8 inch (0.3cm)
for the bar tacks. If you have a very
thick button, add more to the diameter
measurement.
Mark the position and length of the
buttonhole on the fabric with tailor’s
chalk.
a: Raise the presser foot and press on
the Presser Foot Holder to release
the Presser Foot .
Attach the Buttonhole Foot .
b: Position the fabric so that the needle
is on the mark that is furthest
from you.
Pull the Buttonhole Foot towards
you as far as it will go.
Lower the foot.
Length Dial can be adjusted
between .
Utility Sewing
21
C
C
To Next Page
Loading...
