AEG 110 - Preparing To Sew; Connecting to Power Supply

3
CAUTION: Ensure your fingers are
free from the needle and presser
foot area and do not press the Foot
Controller by mistake which
would automatically start the
sewing machine.
d:TurnonthePowerSwitch to
turnonthepowerandthesewing
light will also automatically turn
on.
c: Insert the Power Supply Plug
intothemainssocket.
b: Insert the Machine Plug into
theMachine Socket .
a:TurnoffthePowerSwitch.
- Please read the important safety
instructions before use.
- Before connecting to the mains
make sure that the rated voltage
show on the rear panel matches
your mains voltage supply.
- Make sure your local voltage is
230V/240V, 50Hz.
Connecting the machine to
power supply
Step 1
PreparingToSew