Step 10
PreparingîToîSew
Note:
Threading the bobbin case
Shuttle cover
Bobbin case
Latch
Tension spring
Pull out about 4" (10cm) of thread.
Ensure the Power Switch is
turned off when removing or
inserting the bobbin case.
a: Remove the sewing table from
the machine by pulling it to the left.
Open the Shuttle Cove by pulling
down the tab on the left of the cover.
Raise the needle to its highest
position by rotating the hand wheel
towards you.
b: To remove the Bobbin Case
from the shuttle pull back the Latch
on the bobbin case and pull
straight out of the shuttle.
c: Place a Bobbin in the Bobbin
Case ,making sure the thread
feeds clockwise from the bobbin.
d: Draw the thread through the slot
in the case.
e: Continue to draw the thread under
the Tension Spring and through
the opening.
11
To Next Page
Loading...
