AEG 110 - Changing the Presser Foot

Step 4
PreparingToSew
Changing the presser foot
Important: Ensure the Power Switch
is turned off when changing the
presser foot.
Needle
Presser foot
Groove
Pin
a:To remove
Turn the Hand Wheel toward you
to raise the Needle to its highest
position.
Raise the Presser Foot to its
highest position using the Presser
Foot Arm .
Press the Press Foot Holder on
the back of the foot holder. the
presser foot will release.
b: To attach
Place the Presser Foot on the
Needle Plate and align the Pin
on the foot with the Groove
of the foot holder. Lower the foot
holder to lock the foot in place.
- Make sure the Presser foot is
secure before use.
- Make sure put down the Presser
Foot Arm before start sewing.
5