16
Step 1
Basic Sewing
Step 2
Note:
The dial can not repeat rotating 360°.
Selecting stitch sewing
Note:
Ensure that the needle higher than
needle plate and fabric before rotate
the stitch selector. Otherwise will bent
the needle.
turn anticlockwise the Hand Wheel
make the calibration tails highest
sewing.
a: Turn the Stitch Selector Dial to
the “A” or “B” position.
b: Adjust the Thread Tension Dial
to 2-6.
c: Length Dial can be adjusted
between 1-4
Lift the presser foot and align the fabric
with the guide on needle plate.
Pull the Needle thread and the bobbin
thread to back and lower the presser
foot.
Slowly press the foot controller
and start sewing along the guide.
Can not continue to rotate the stitch
selector anticlockwise, but reverse
rotation when the dial is at “ ” .
Can not continue to rotate the stitch
selector clockwise, but reverse
rotation when the dial is at “L”.
Otherwise it maybe damage the
stitch selector.
Reverse sewing is used for locking the
end of seams and where
reinforcement is need.
Reverse sewing
At the end of a seam, press down on
the Reverse sewing lever and
touch the foot controller lightly.
Sew a few reverse stitches.
Release the reverse sewing lever and
the machine will sew forward again.
4
1
2
3
0
calibration tails
To Next Page
Loading...
