Utility Sewing
calibration tails
Step 3
Step 4
Note:
- Ensure that the needle higher than
needle plate and fabric before
rotate the stitch selector. Otherwise
will bent the needle.
Blind seam
Set the Stitch Selector Dial to “F”
“G” “H” or “L”.
the Thread Tension Dial to 1-4.
Length Dial can be adjusted
between 1-4.
Adjust the thread tension so that the
upper thread appears on the reverse
side of the fabric. Test on a scrap
piece of fabric first to get the best
results.
Note: When sewing very thin fabrics,
it is recommended that you use
interfacing on the backside of the
fabric.
Decorative stitch
-Rotate the Hand Wheel
anticlockwise (toward you) to bring the
thread take up lever to highest position.
But incorrect the Hand Wheel
rotating direction will cause upper
and bobbin thread blockage upper
the needle plate.
Turn anticlockwise the Hand Wheel
to make the calibration tails highest
sewing.
Set the Stitch Selector Dial to
“K” or “L”.
Set the Thread Tension Dial to 1-4.
Length Dial can be adjusted
between 1-4.
For loose or thick fabric you can
overlock the raw edge, fold the fabric
and leave approx 1cm hem.
After sewing press the fabric to make
the blind stitch visible on its face side.
When sewing allow the needle to just
pass through the fold of the fabric.
20
To Next Page
Loading...
