PREFACE
This manual contains instructions for installing and programming the Micro 84
Programmable Controller. Section 2 describes the system components: controller,
input/output modules, and programming devices. Installation is outlined in
Section 3. System checkout is described in Section 4. Section 5 details the theory
of operations. The P370 Programmer is described in Section 6 and programming
procedures are given in Section 7. The P371 Program Pack, a device for
transferring user programs is described, in Section 8. Four appendices, A through
D, list error codes, supply programming examples, define terms, and give
information on l/O modules.
RELATED PUBLICATIONS
ML-M84A-REF Reference Card
PI-M84A-001 Programming Guide IP190
PI-J375002
J375 Modbus Interface
PI-J378-002 J378 Modem
“The information in this document is subject to change without notice and should
not be construed as a commitment by Gould Inc., Programmable Control Division.
Gould Inc., assumes no responsibility for any errors that may appear in this
document.”
The following are trademarks of Gould Inc.:
Modicon 184
Micro 84 384
Modbus 484
Modvue 584
Modway
584M
584L
884
P180
P190
0 Copyright 1981, Gould Inc.
Printed in U.S.A.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
