AEG Protect D Series - User Settings

47
Control
Go to bypass
Battery
test
Reset error state
Load segments
Settings
Sets parameters
Event log
Event list
Identification
[Type model] / [Part/Serial
number] / [UPS/firmware]
6.5 User settings
The following table displays the options that can be changed by the user.
Submenu
Options on the display
Default
Change
language
[English], [German] , [French],
[Spanish], [Russian]
If user select German for display
language,
Option item display as below:
[Englisch], [Deutsch], [Französisch],
[Spanisch],
[Russisch]
English
User
password
[enabled<****>], [disabled]
disabled
Audible
alarms
[enabled], [disabled]
enabled
Set date and
time
mm/dd/yyyy; hh:mm
01/01/201
9
08:00
Relay
configuration
[UPS ok], [on bypass], [on Economical
mode(ECO)], [on High
efficiency(ECO+)],
[on battery], [battery low], [battery
fault],
[battery missing], [Fan fault],
[Summary Alarm]
UPS ok
Control
commands
from serial
port
[enabled], [disabled]
e
nabled
Output
voltage
[200V], [208V], [220V], [230V],
[240V], [autosensing]
autosensing
Output
frequency
[50Hz], [60Hz], [autosensing]
autosensing