28 Aermec cod. 5806715_00 12.01
NRP 0200-0750
EN
20. GENERAL WARNINGS
AERMEC NRP heat pumps are constructed according
to the recognised technical standards and safety
regulations. They are designed for summer and winter
conditioning and the production of domestic hot
water. Any contractual or extracontractual liability of
the Company is excluded for injury/damage to persons,
animals or objects owing to installation, regulation
and maintenance errors or improper use. All uses not
expressly indicated in this manual are prohibited.
20.1. PRESERVATION OF THE DOCUMENTATION
The instructions along with all the related
documentation must be given to the user of the
system, who assumes the responsibility to conserve
the instructions so that they are always at hand in case
of need.
Read this sheet carefully; the execution of all works
must be performed by qualified staff, according
to Standards in force on this subject in different
countries.
20.2. INSTALLATION
The unit must be installed in such a way that
maintenance and/or repairs can be carried out.
20.3. WARRANTY
The appliance warranty does not cover the costs for
ladders, scaffolding, or other elevation systems that
may become necessary for carrying out servicing under
warranty.
Do not modify or tamper with the heat pump
as dangerous situations can be created and the
manufacturer will not be liable for any damage caused.
The validity of the warranty shall be void in the
event of failure to comply with the above-mentioned
indications.
20.4. WARNINGS REGARDING SAFETY AND
INSTALLATION STANDARDS
The heat pump must be installed by a qualified
and suitably trained technician, in compliance with
the national legislation in force in the country of
destination.
AERMEC will not assume any responsibility for
damage due to failure to follow these instructions.
Before beginning any operation, READ THESE
INSTRUCTIONS CAREFULLY AND CARRY OUT THE
SAFETY CHECKS TO AVOID ALL RISKS. All the staff
involved must have thorough knowledge of the
operations and any dangers that may arise at the
moment in which the installation operations are
carried out.
21. PRODUCT IDENTIFICATION
The NRP multipurpose appliances can be identified
through:
PACKING LABEL
which shows the product identification data.
TECHNICAL PLATE
ATTENTION
Tampering, removal, lack of the
identification plate or anything
else does not allow the sure
identification of the product
and will make any installation
or maintenance operation to be
performed difficult.
TECHNICAL SECTIONINSTALLATION SECTIONUSER SECTION
Standards complied with
WHEN DESIGNING and
CONSTRUCTING the unit:
SAFETY
1. Machinery directive
2006/42/EC
2. Low voltage directive
LVD 2006/95/EC
3. Electromagnetic compatibility
directive EMC 2004/108/EC
4. Directive regarding pressurised
devices PED 97/23/EC, EN 378,
5. UNI12735, UNI14276
ELECTRIC PART
1. IEC EN 60335240,
2. IEC EN 6100061/2/3/4
ACOUSTIC PART
1. ISO DIS 9614/2
intensimetric method
PROTECTION RATING
IP24
REFRIGERANT GAS
This unit contains fluoride gases with
greenhouse effect covered by the Kyoto
Protocol. Maintenance and disposal
must only be performed by qualified
staff, in compliance with standards in
force.
To Next Page
Loading...
Need help?
General
