AERMEC SC1200 User Manual

35
17.4. SETTING THE FAN SPEED
If the unit is on (and the automatic or dehumidification modes
are not selected), pressing the button allows the se-
lection of the fan speed. Pressing the button allows changing
the fan speeds as shown in the icons below, in the following
sequence:
Setting the fan speed
AUTO Minimum Averaged Maximum
NOTE:
Besides the three speeds (AUTO automatically selects the
best speed based on the room temperature), there is a
function called TURBO (explained earlier) which adds a
further speed above the maximum speed.
17.5. SETTING THE MOTORISED DISCHARGE FIN (SWING)
If the unit is on, pressing the key (or the key)
allows the activation of the swing function of the motorised
discharge fin. This fin varies the direction of the flow of air into
the ambient, on the basis of the selected position. The con-
trol logic of this function is split between two different modes
(to pass from one mode to the other press simultaneously
the and buttons with the unit switched off. If the
function has been correctly set the remote control display will
flash for two seconds the icon ):
• SIMPLIFIED mode: this is the default active mode. Pressing
the button shown above allows the swing of the fin to be
activates or deactivated. Once activated (the icon
is displayed) the swing is continuous, from the lowest to
the highest point. To stop the fin in a particular position it
is necessary to press the button again, once the
desired position is reached.
• COMPLETE mode: With the unit on, pressing the
button allows the setting of the following sequenced
steps, one by one:
Motorised discharge fin
setting
Continuous
Fixed
(Step 1)
Fixed
(Step 2)
Fixed
(Step 3)
Fixed
(Step 4)
Fixed
(Step 5)

AERMEC SC1200 Specifications

General

Brand	AERMEC
Model	SC1200
Category	Air Conditioner
Language	English