41
17.16. SETTING THE UNIT OF MEASUREMENT
The unit can display the temperature values in °C or in °F. To
change the unit of measurement simultaneously press the
and buttons with the unit switched off. The tem-
perature value on the remote control’s display is automati-
cally converted.
Setting the unit of meas-
urement
17.17. REPLACING THE REMOTE CONTROL’S BATTERIES
To replace the batteries of the infra red remote control pro-
ceed as follows:
1. Open the battery cover by sliding it in the direction of
the arrow.
2. Remove the old batteries.
3. Insert two new 1.5V alkaline high performance batteries,
type LR03 (AAA), taking care not to reverse the polarity.
4. Close the battery cover.
1
2
3
4
NOTE:
• When batteries are replaced use new batteries of the
recommended type.
• Remove the batteries if the remote control is not used
for extended periods.
• The remote control can emit a signal up to a maxi-
mum distance of 7 metres.
• The unit can be affected by signals transmitted by
remote controls for televisions, video recorders, or
other devices used in the same room.
WARNING:
In the event of loss or damage of the remote control
the unit can be started and stopped using the emer-
gency button as indicated in section 8.1.
To Next Page
Loading...
Need help?
General
