AERMEC SC1200 - Remote Control

31
16.1. REMOTE CONTROL
• Some of the buttons of the re-
mote control are not used for the
required air conditioner and are
therefore not described in these in-
structions. Pressing of these keys will
not affect the operation of the air
conditioner.
• Check there are no obstructions
between the receiver and the re-
mote control.
• The maximum distance between
the IR receiver and the remote
control is 8 metres, to ensure the
signal is correctly received.
• Position the remote control at least
1 metre away from TVs, radios, ste-
reos, etc. There may be some au-
dio and video interference.
• Do not drop or throw the remote
control.
• Do not let liquids enter the remote
control, and do not leave it in di-
rect sunlight or in hot places.
• When the remote control sends a
signal the symbol appears on
the display, the receiver of the in-
door unit emits a sound to confirm
reception of the signal.
2
3
6
11
1
4
5
8
9
10
14
12
13
Alarm Function of the button:
1
Switches the unit on or off
2
Operating mode selection
3
Increases value (operating set-point, timer, etc.)
4
Decreases value (operating set-point, timer, etc.)
5
Sets the fan speed
6
Sets the operation of the motorised vertical air discharge fin (swing function)
7
Sets the operation of the motorised horizontal air discharge fin (swing function)
8
This button allows to manage two different functions: the left side of the button activates or deactivates the air ionizer
device for air sanitation; the right side activates or deactivates the energy saving function (this function is can only be
applied to the cooling mode)
9
Sets the function for extended ventilation
10
Shows on the indoor unit display the temperature set-point and the room air temperature
11
Activates or deactivates the timer ON and timer OFF function
12
Activates or deactivates the maximum fan speed (TURBO)
13
Activates or deactivates the SLEEP function (this function is applicable to the cooling and heating modes). Once
activated this function will control the unit in order to maintain an ideal temperature (this temperature is automatically
calculated and cannot be set)
14
Activates or deactivates the display of information of the indoor unit
Keys available
on remote control
7