AERMEC SC1200 - Activating; Deactivating the Turbo Function; Activating; Deactivating the Night-Time Comfort Function

39
17.12. ACTIVATING / DEACTIVATING THE TURBO FUNCTION
The unit allows the setting of three fan speeds during the var-
ious operating modes (except the automatic mode and the
dehumidification mode). There is an additional speed called
turbo.
If the unit is on, pressing the button activates or deacti-
vates this function. If the function is active the icon is shown
on the remote control’s display.
Setting the
TURBO function
17.13. ACTIVATING / DEACTIVATING THE NIGHT-TIME COMFORT
FUNCTION
The night-time comfort function controls the air conditioner
in an optimal way during the night. The following logic is ap-
plied:
• In cooling or dehumidification: after an hour of opera-
tion the set-point is raised by 1° C, after two hours of op-
eration the set-point is raised by 2° C;
• In heating: after an hour of operation the set-point is low-
ered by 1° C, after two hours of operation the set-point is
lowered by 2° C;
If the unit is on (except in automatic or ventilation mode),
pressing the activates or deactivates the night time
health function. If the function is active the icon is dis-
played on the remote control.
Setting night-time com-
fort function
NOTE:
The night time health function is deactivated by switching
off the unit, and on restarting will not be active; this func-
tion can be activated at any time.