MAINTENANCE MANUAL
IFR 6000
2-2-2
Page 2
Aug 1/06
B. Precautions
(1) Safety
WARNING: REMOVE ALL JEWELRY OR OTHER COSMETIC APPAREL BEFORE
PERFORMING ANY TROUBLESHOOTING INVOLVING LIVE CIRCUITS.
WARNING: WHEN WORKING WITH LIVE CIRCUITS OF HIGH POTENTIAL, KEEP
ONE HAND IN POCKET OR BEHIND BACK TO AVOID SERIOUS SHOCK
HAZARD.
WARNING: USE ONLY INSULATED TROUBLESHOOTING TOOLS WHEN WORKING
WITH LIVE CIRCUITS.
WARNING: FOR ADDED INSULATION, PLACE RUBBER BENCH MAT UNDERNEATH
ALL POWERED BENCH EQUIPMENT, AS WELL AS A RUBBER MAT
UNDERNEATH TECHNICIAN'S CHAIR.
WARNING: HEED ALL WARNINGS AND CAUTIONS CONCERNING MAXIMUM
VOLTAGES AND POWER INPUTS.
(2) ESD
CAUTION
THIS EQUIPMENT CONTAINS PARTS
SENSITIVE TO DAMAGE
BY ELECTROSTATIC DISCHARGE (ESD)
CAUTION: THE POWER SUPPLY ASSY, MULTI-FUNCTION PCB ASSY, RF ASSY
AND PROCESSOR PCB ASSY CONTAIN PARTS SENSITIVE TO
DAMAGE BY ELECTROSTATIC DISCHARGE (ESD). ALL PERSONNEL
PERFORMING TROUBLESHOOTING PROCEDURES SHOULD HAVE
KNOWLEDGE OF ACCEPTED ESD PRACTICES AND/OR BE ESD
CERTIFIED.
(3) EMC and Safety Compliance
All assemblies, cables, connectors, plastic fasteners, gaskets, fingerstock and
miscellaneous hardware within the Test Set are configured to satisfy the safety and
EMC compliance standards.
CAUTION: UPON COMPLETION OF ANY MAINTENANCE ACTION; ALL ASSEMBLIES,
CABLES, CONNECTORS, PLASTIC FASTENERS, GASKETS,
FINGERSTOCK AND MISCELLANEOUS HARDWARE MUST BE
CONFIGURED AS INSTALLED AT THE FACTORY.
To Next Page
Loading...
Need help?
General
