Original Instructions Rev.1.0 User Manual ā Isa 12/ 42
Operating the ISA centrifuge - AFI-CI060
First Start
The first start must fulfill the conditions of the IEC 61010-2-020 safety standard
HOW TO GREASE A ISA CENTRIFUGE
Rotor assembly
Clean and lubricate the motor shaft by depositing a thin film of the
food grade grease supplied.
Place the rotor above the drive shaft.
Slide the rotor on the drive shaft.
Use the provided wrench to tighten the rotor nut onto the motor
shaft.
Remove the wrench
Clean and lubricate the pins by depositing a thin film of the food
grease supplied.
Grab the synthetic grease container provided with your centrifuge.
Dispense a small amount of grease on each of the following locations:
To Next Page
Loading...