Original Instructions Rev.1.0 User Manual ā Isa 13/ 42
Position the buckets
Swing-out rotors are used with round and square buckets or
microplate buckets.
Place the buckets & lids in the corresponding numbered locations.
First powering
After transport, wait at least 2 hours before putting the appliance
into operation so that the refrigerant circuit is fully efficient. Connect
the power cord to the mains.
Press & maintain the START-STOP button onto the control panel,
until display powering.
An animation starts during the initialization phase.
The parameters of a program appear.
Note: To enter the standby mode, press and hold the START / STOP
key: Only the knob remains illuminated.
Opening the lid
On the first start, the lid may not open right away due to a long storage in a cold
environment.
In this case, warm-up the hinge spring by repeated manual shifting of the lid
downwards.
To open the lid, press the button on the right side.
During a first start, it is possible that the lid does not open frankly after prolonged storage. In this case, activate the spring
hinges by manually manipulating the cover from top to bottom.
To close the lid, lower the lid and press until click.
To Next Page
Loading...
