AFi ISA - Operating; Settings; Set Speed; Set Duration

Original Instructions Rev.1.0 User Manual – Isa 16/ 42
Operating
Settings
Program setting is done adjusting successively following parameters:
 Speed
 Cycle Duration
 Temperature
 Acceleration Slope
 Braking slope
Set Speed
#
Action
Instruction
Effect
1
Select the program number spinning
the knob.
The program number is displayed under
"Prog".
2
Press & hold validation button.
The selected program is now in
Modification mode.
Speed value is now blinking.
3
Modify blinking value spinning the
knob.
The speed value is modified.
Default setting unit is rotation per
minute (rpm).
To modify the unit, refer to § 4.11.1 Set
Speed Unit / Centrifuge Force
4
x6 (on
refrigerating
model)
Press validation button 6 x to validate.
(On ventilated model, press 5x)
The modification of the selected
program is saved.
Set duration
#
Action
Instruction
Effect
1
Select the program number spinning
the knob.
The program number is displayed under
"Prog".
2
Press & hold validation button.
The selected program is now in
Modification mode.
Speed value is now blinking.
3
x1
Press 1x to access to duration
parameter.
Duration value is blinking.
4
Modify blinking value spinning the
knob.
The duration value is modified.
Default setting unit is minutes : seconds
(min:sec).
5
x5 (on
refrigerating
model)
Press 5 x to validate.
(On ventilated model, press 4x)
The modification of the selected
program is saved.
Set Temperature (Refrigerating model)
#
Action
Instruction
Effect
1
Select the program number spinning
the knob.
The program number is displayed under
"Prog".
2
Press & hold validation button.
The selected program is now in
Modification mode.
Speed value is now blinking.
3
x2
Press 2x to access to temperature
parameter.
Duration value is blinking.