Originale Instructions- Rev.1.3 User Maunal– Loreena 26/ 68
Access to the list of programs by pressing this icon :
Select the pre-warming program:
Start the cycle by pressing
The temperature inside the bowl will show on the display
This program is set to warm the centrifuge up to 20°C during
a 20min cycle at 3,500 RPM. Acceleration and Deceleration
slope are both set on 9 and cannot be modified.
Start the cycle by pressing
The temperature inside the bowl will show on the display
4.11. Routine Menu
The routine program allows you to modify the cycle parameters without seeing the automatic request for backup at each
change.
It is therefore necessary to press the "Save" key to save the parameters.
Select the program "0" or "...".
It is possible to modify the parameters.
If no backup is performed, the settings will not be saved when
the power is turned off.
4.12. Other menus
To Next Page
Loading...
